Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Sherman Oaks Owner’s Guide

Ghost Controls keypad and intercom repair in Sherman Oaks typically runs $210 to $390 installed, and we keep the most common replacement keypads and intercom modules on the truck so most visits are a one-and-done. The part fails in predictable ways: buttons stop registering, the backlight quits, or the intercom audio gets thin and crackly. Owners usually notice on the worst possible morning, keypad dead at 7 a.m., gate refusing the code, a car idling on the driveway. By the time you call us, you have probably already tried new batteries, cleaned the face, and stared at the thing hoping it would come back to life.

Call (925) 590-4289

Key takeaways:

• We stock Ghost Controls-compatible keypads and intercom parts for most AXDP, AXXP, and universal-mount models.
• Installed pricing is settled before we turn a single screw. No surprises on the bill.
• Same-day service is available for keypad and intercom failures in most Sherman Oaks neighborhoods.
• We are an independent gate company. We are not affiliated with Ghost Controls, but we service their equipment every week and know its failure points intimately.

Which Ghost Controls Models This Applies To

Most Sherman Oaks homes with a Ghost Controls opener fall into one of two camps: the AXDP series (the wireless keypad with the flip cover) or the newer AXXP touchpad. The intercom side is usually a Ghost Controls-branded two-wire audio module paired to a wall-mounted call button at the driveway. The compatibility gotcha that trips up a lot of owners: the AXDP-1 and AXDP-2 look identical from ten feet away, but the -2 is a rolling-code unit and will not pair to an older fixed-code receiver. If you pull the battery cover and find a label that says “RC” anywhere, you have a rolling-code keypad. That distinction alone saves a second service call when someone orders the wrong part online.

We match OEM Ghost Controls parts first. When an owner asks about aftermarket, we are honest about the tradeoff: generic universal keypads cost $40 less up front, but they miss the weather-sealing spec and the button travel feels different within a year. For a part that lives outside in Los Angeles sun and the occasional winter downpour, the OEM or a known-good equivalent is the square deal. We stock genuine Ghost Controls keypads, the rolling-code modules, and weatherproof intercom units for the models we see most across the Valley.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• Buttons need multiple hard presses before the gate moves. The carbon contacts under the membrane have worn down. This is the most common Ghost Controls failure in Sherman Oaks, especially on gates that face afternoon sun. Heat accelerates the wear.
• The backlight stays dark even with fresh batteries. The internal LED board has corroded or cracked a solder joint. This is repairable only by replacing the keypad assembly; there is no practical board-level fix in the field.
• The code works, but the intercom buzzer at the house rings weak or not at all. The audio module’s capacitor has dried out, or the two-wire run from the driveway has a nick letting in ground noise. We test both before quoting a part.
• The keypad accepts the code but the gate only opens halfway or not at all. This is usually not the keypad. It is the opener’s receiver or a limit setting. We check the whole chain before selling you a part you do not need.
• After rain, the keypad works intermittently. Water has found its way past the gasket. In a Sherman Oaks winter, that is a death sentence for the board if left alone. The fix is a new sealed keypad and a fresh bead of silicone on the mount.

Replacement Cost & What’s Included

For Ghost Controls keypad replacement in Sherman Oaks, plan on $210 to $290 installed for a standard AXDP or AXXP unit. Intercom module replacement runs $260 to $390 depending on whether we are replacing the outside call station, the inside audio unit, or both. Parts make up roughly 60 percent of that number; the rest is the service call, the programming, and the two-point wiring check at the opener and at the house. Every price is quoted and agreed before any work starts. We do not hand you a bill with a different number on it.

Every keypad and intercom repair we complete in Sherman Oaks carries the 90-Day Done Right Promise. If the part or our work fails inside ninety days, we come back and make it right. Written, no paperwork, no arguing. Victor Salinas has been fixing gates in this area long enough to know that a guarantee only means something if the company answers the phone when you call on it.

DIY or Call Us?

A Ghost Controls keypad and intercom runs on low voltage, so the electrical risk is minimal. The honest question is whether you want to spend a Saturday chasing a part, matching a model number, and pairing a rolling-code unit that will not talk to your older receiver. What an owner can safely check: battery condition, obvious corrosion on the terminals, and whether the mount screws are tight. What goes wrong on a DIY attempt: buying the wrong -1 or -2 variant, stripping the weatherproof gasket, or mis-wiring the intercom so the house bell rings continuously. None of those are dangerous. All of them cost more to undo than the service call would have cost.

If you would rather hand this off, call (925) 590-4289. We will confirm the model over the phone, bring the right part, and have the keypad programmed and the intercom talking before we leave.

FAQs